Felder - Thicknessing machines
Hammer D951
Surfacers: preset blades, with maximum precision time to change them
Produced with the highest precision adjusted from factory, kill the annoying work of setting time to change the blades on the brush, also as the acquisition of expensive setting gauges. -Change of blades in less than 2 minutes - preset blades, with maximum precision time to change them. -Change of blades in less than 2 minutes - preset blades, with maximum precision at the time of the thicknesser table cambiarlas.d. Side slips the thicknesser table with precision thanks to the longitudinal guides. These longitudinal guides Dim (A + B) also the tension of progress towards the exit to the surface side.
-Change of blades in less than 2 minutes - preset blades, with maximum precision time to change them.
-The screws of tightening will not stick with resin.
-Low noise thanks to the acoustic design.
-Maximum length of the edge of the blades.
-Cost savings thanks to the economic price of the blades.
-With a scope of edge of 120 mm circle
-Gripping bars articulated in combination with introduction rolls of rubber for simultaneous work of wood of different thickness.
-Change of blades in less than 2 minutes - preset blades, with maximum precision time to change them.
-The screws of tightening will not stick with resin.
-Low noise thanks to the acoustic design.
-Maximum length of the edge of the blades.
-Cost savings thanks to the economic price of the blades.
-With a scope of edge of 120 mm circle
-Gripping bars articulated in combination with introduction rolls of rubber for simultaneous work of wood of different thickness.
