Insert of double a-side for quick removal of metal
The face of superior detachment of this insert mounted at the same level that the top of the body of the tool, allowing the chips to flow freely without any obstruction. The four helical cutting edges ensure positive radial angles of detachment and a soft material penetration to mechanise. Low forces and under loads of Court provide a greater length of the Insert, greater stability and the possibility of machining large depths of cut with great strides. The beamformer of shavings, with small ribs, deforms and breaks the shavings into small easy to remove from the cutting area segments.
The insert has a frontal angle of 3.7o and side of 6th, allowing machining escuadrando to 90 °.
The Heliturn offers their best results to be used at very high depths of court, up to 8 mm, and advances of up to 1.2mm/v to cut steel. On surfacing, the maximum cutting width is limited to fittings (half of the width of the insert).
Compared to size 16 CNMG/M or WNMG/M 13 plates, with the same radio tip, 1506 LNMX - HT offers a remarkable longer life of the tool.
Iscar has recently added a smaller size to the family Heliturn, the LNMX 1104..R/L-HT insert, and the corresponding tool, for the range of applications of machining medium, with a depth of cut of up to 5 mm. The new insert presents all the characteristics of the larger plates. This increases its economic advantage in the range of applications of medium machining.
From the plates of CNMG/M 12 or 08 WNMG/M size with the same radius of tip, you get a longer life of the Insert.
The plates are available with radius of tip of 0.8, 1.2 to 1.6 mm.
The Heliturn plates are manufactured in the most advanced grades: IC9025, IC3028, IC428, IC907 and IC908.
The tool of foreign are manufactured with the handle of 20, 25, 32 and 40 mm sizes The bars of mandrinar, with sizes of 25, 32, 40 and 50 mm. There are also available interchangeable heads. All these tools have unique coating "hard touch" of Iscar, which provides a longer duration of locked and excellent corrosion resistance.
As a result of the positioning of the Insert, next to the counterpoint machining is possible.
The angle of very positive detachment of these tools allow a power consumption of 10-15% lower that the conventional tools by applying the same parameters.
With the use of these tools are guaranteed great savings in costs and profitability in operations of turning.
