Gneuss shows its latest in process, filtration and measurement in the K
September 10, 2010
Process technology
Since its introduction three years ago, MRS extruder has become a dominant technology for the process of the scales of PET post-consumer without presecado. Thanks to its patented combination of addition mono screw along with a section of multiple screws is an extruder "particularly robust, simple operation and low maintenance costs".
Gneuss exhibited in K for the first time a complete line for direct recycling of waste of light fibre and film, which includes an extruder MRS 110, equipped of a combination of Cutter/feeder with a filter RSFgenius 150 and viscosity VIS online meter. With this line, the light scrap of fiber and the film can be processed in one step with comparable products to others produced with Virgin material, with an index of production of the process of 500 to 700 kg/h.
Filtration technology
In the area of technology of filtration products, Gneuss will present their Rotary filtration systems of molten mass, with new and enhanced designs. With the latest generation of RSFgenius melt filtration systems, Gneuss has spread again its "technology leadership" achieving new levels of reduction of the loss of materials in the process of self-cleaning and decreasing the energy consumption of your computer", achieving levels not achieved so far in the market."
Thanks to the optimization of the cleaning (which now controls fully electronically) and the further improvement of the heating and insulation, filtration with the models of RSFgenius quality is even more efficient.
All models for the lines of extrusion of average between 500 and 4000 kg/h capacity now have an active area of more than 40% filtration. In many cases, this allows the use of a smaller model with the same level of production and quality of filtration, greatly reducing the cost of the investment.
The company will showcase a filtration system of melt SFXmagnus, which incorporates a powerful drive for applications of high pressure system.
Measurement technology
Gneuss will also show the range of producctos of the business unit of measurement technology, which includes mass, which is now pressure transducers are suminstran without mercury. Pressure sensors for mass of NTX, which can be used without any restrictions in high temperature applications, have a deviation extremely low temperature.
The second novelty Gneuss will present in Düsseldorf is the monitoring system of the pressure of the extruder (EPM) that ensures a high level of security for operators and machines. With the EPM system, Gneuss is the first company to respond and adapt to the new European guidelines for the extrusion (1114) that came into force earlier this year, and specifying higher levels of security of court with respect to the overloading of pressure in the twin-screw.