Mass Transplast teaches a variety of equipment for the handling of products in powder form in bulk at Equiplast 2008

Mass Transplast has developed different machines for the recycling of plastic material, including the mills 40.40 BA and BA 62.40. of medium and large dimensions, available with 3 or 5 rotating blades. These mills facilitate the recovery of scrap of large dimensions without the need to pre-cut injection presses. All parts that can be opened, van equipped rapid closure for quick and easy access to the interior of the molino, simplifying maintenance operations. It also has several electronic and mechanical protections allowing access to the interior of the House of crushing only with the rotor stationary, guaranteeing maximum safety to operators.

The centralized pneumatic supply systems can feed any machine processing with any product at all times.

The supply systems integrate all additional functions as dehumidification and drying, both gravimetric and volumetric dosing and recovery and recycling of various materials.

The implementation of these systems allows to obtain significant economic benefits, recovery and recycling of various materials.

Mass Transplast done, after a custom study, installations of pneumatic feeding centralized to automate all processes of maintenance of the products in the plastics processing industry.

These facilities range from the storage of the raw material in silos to the distribution of these different equipment for transformation, integrating all the complementary functions.

Trio is the most recent dosage mass Transplast has been developed to meet the needs of the transformers in the field of extrusion and thermoforming needing a system as automatic as possible in the change of different productions of start-up (high amounts of grinding material) and the implementation scheme of the machine (low amounts) (of grinding material).

This change in production, usually done by hand, is used by the management system SW707, with which it is possible to program the different working conditions and the quantities of milled material.

Overall, the dispenser with three phase motors, how hopper loading and synchronization of rotating level sensors, has the possibility of using recipes which provide for the use up to 100 per cent of ground. In the implementation of this system the significant volumes of the ground light, have taken into consideration in this has been developed to perform lots of work and with a discharge zone allowing the passage of the material.

Horizontal mixer, with three phase motors and modular pallet, is built with a semi-esférico Fund to guarantee the homogeneity of the components.

The dehumidifiers of molecular sieves of series D represent the ideal solution in the sector of dehumidification of plastic materials.

Indispensable for hygroscopic materials and materials requiring a very low residual moisture content before the transformation, the dehumidifiers of series D reach large benefits in terms of Dew Point (- 60 ° C) and use.

They offer the following advantages:

• Flow of air with constant hopper.
• Blowers of high altitude drive.
• Filters for the protection of the blowers.
• Torres carries stainless steel sieves.
• Dimensions reduced in line with the demands of modern life.
• Electronic control of temperature and protections of security such as absence of compressed air, excessive temperature, etc.

The volumetric fillers have a capacity of dosage of 0.1/800 kg/h (type DS1/DS4). Its operation is fully automatic microprocessor-controlled, calculated the speed of rotation and the time of dosing, raising the percentage to measure the weight of production time if it's extrusion or moulding.

Mass Transplast has a wide range of feeders tyres for the transport of raw materials in the plastics processing industry.

Single phase pneumatic feeders ranging from 55/180 kg/h (hopper of 4/9 l - engine 900/1100 W) to feeders triphasic tyres up to 1,500 kg/h (22/40 l hoppers - turbines of 1.3/7.5 kW), all them with automatic filter cleaning.