Iscar Ibérica, S.A. in the 2006 BIEMH
The new DR-MF tools incorporate Hard Touch coating, which provides greater resistance to wear and reduces the coefficient of surface friction on the lips of the drill, which facilitates removal of swarf.
Family of rectangular double-sided with 4 cutting edges spiral insert
The new rectangular insert Helido H490 ANKX 170608PNTR has 4 helical cutting edges to right-wing and is very thick and resistant.
The insert is set in a seat leaning in tail of Milan, which offers an extremely rigid fixation and reduces the tension of the screw.
The insert has a facet, obtaining an excellent surface finish.
The tip RADIUS standard is 0.8 mm.
Due to its solid structure and the exclusive beamformer of shavings with positive cutting angles and excellent combinations of qualities; the new family is characterized by durability and low cutting forces.
The new insert can be used for the machining of steel, stainless steel and cast iron, with a few very high cutting parameters.
The strawberries and mango are available in a range of diameters from 32 to 50 mm and the hollow in a range of 40 to 160 mm. All hollow strawberries, from 50 mm in diameter, are available with fine and wide passage.
They can escuadrar to 90 ° up to 16 mm of depth, plongeé with Rails of up to 10 mm, and can perform operations of slotted and planned.
Rhombus insert of 80 degrees with cutting edge Helix to a high rate of removal of metal
Edges of a rapid extraction of metal cutting
Iscar presents a new family of strawberries using plates with tangential fixation.
It is the first global design which combines tangential fixation, 4 cutting edges and geometry positively in the range of diameters that are presented.
Tangential insert for a tip for tronzado
Iscar also exhibits the new insert of a tip for tronzado Tang-Grip with an ingenious system of fixing.
Features:
• Very rigid fixation in a seat tangentially oriented. It increases the length of the seat three times with respect to any other conventional system.
• Allow machining with high advances and provides an excellent flatness and surface finish.
• Solves the problem of escape from the plates during the shrink back to the Court. It has a full CAP, in contrast to the strength of retention of the existing systems. (Of particular importance in machines with feeders of bars or sub-husillos)
• Tang-Grip, the forces of machining hit a back wall long and rigid in the system. Wear and tear on the seat, which occurs during machining and in the replacement of the plates in other systems, reduces the strength of attachment. This does not happen with the new Tang-Grip system.
• The Tang-Grip system, provides a repeatability of slotted very precise.
• TTang-Grip, offers a free chips and without obstructions, very important in slotted/tronzado flow deep, because there is no upper flange that interferes, as in other systems.
• The superior in conventional auto fixing systems flange wear reduces the strength of attachment, while there is no influence on this force in the new system. The flexible flange is protected by the Insert.
• The result of the combination of the tangential attachment and a free chip flow is a longer duration of the tool and the seat.
• The TAG chips are available with the usual unionized type J and C, neutral and with hand.
• New shade using a specific key of fixation and extraction easy to use. This new family includes, in a first phase, lamas and plates of 3-4 mm broad on IC928 and the new as IC908 Al - TEC. The lamas are of standard dimensions to mount in the blocks of ISCAR and graduates to facilitate the adjustment of the cantilever.
The recommended conditions of court and functioning are similar to the of our other systems from a single mouth tronzado, obtaining better results.