Egasca, S.A. in the 2006 BIEMH
The machine consists of an upper turret with additional displacement over the axis "And" - which greatly facilitates the operations of milling as well as allowing operations outside city centre - and twelve motorized stations, a lower turret with other twelve motorized stations and two heads at loggerheads with the C in both axis control.
Among the features that comes up before the other models in the ABX series, include the following:
• Has risen markedly tours on the z-axis of the two turrets so they can work without distinction and without interference well on a head or on the other.
• The machine has an electronic system of confirmation of tronzado that detects possible breakage of the tool of crosscut.
• The area of work of the machine presents a greater accessibility which makes it more convenient preparation of the machine and change of cutting tools.
New series of centres of turning
The models in this series are available with two different benches, three different plate sizes, turret motorized displacement on the shaft "And" and subhusillo for the machining of parts from the rear.
The bed has been built in cast iron mehanítica FC-35 in one piece with what gets extreme rigidity and an extraordinary capacity of absorption of vibrations caused by operations of machining in the most severe conditions.
All the contact surfaces of cars, turret, accommodation of the spindles to balls, etc., have been rasqueteados by hand in order to provide maximum precision in the Assembly, an extraordinary structural rigidity and an optimal distribution of burdens.
Regulators and servo motors are Fanuc series "i" and the control is the 18i-T with conversational Programming Manual Guide I.