Okuma creates a new range of turning and milling integrated

Models MacTurn 250, 350 and 550, which can come equipped with multiple configurations, such as lower turrets motorized or not, subhusillos or diverse storage capacity of tools are available.

Okuma is also a center of 5 continuous axes vertical machining to the aerospace market. MU-400 VA is the first model that sees the light of the series MU, based on the current series MB of great acceptance in the market. The machine features a rotating Panel of high speed and high precision (Trunnion construction).

The most important improvements of this model are an increase in the power of the engine and pair, a preview of court a third fastest and a reduction of 50% at the turn of the tool. Also multiplied by four speeds of the axes A and C. Increased also the dimension of the table and the dimension of the piece to mechanise. The load carrying capacity is up to six times higher.

This should add a new range of multifunction lathes equipped with two turrets and two spindles. The first models are LT200M and LT300M and both offer the possibility of incorporating a shaft and.

These lathes reduce time of machining up by 40 percent compared with a conventional lathe.

The advantages of this type of lathe are turrets to work with both spindles and the greater power of the main engines. They have built-in function of motorization of the tool (M) that increases the power by 65 percent, as well as a greater mechanical rigidity.