This news article was originally written in Spanish. It has been automatically translated for your convenience. Reasonable efforts have been made to provide an accurate translation, however, no automated translation is perfect nor is it intended to replace a human translator. The original article in Spanish can be viewed at
Rodicar Hidráulica, en la Biemh 2008Pavilion 3 Stand C-74 •
Rodicar hydraulics in the Biemh 2008
February 21, 2008
Rodicar hydraulic is a company with much to say to the visitors of the biennial. The Engineering Department of this company dedicated to the manufacture of bombs, managed to eliminate their problems of loads of bars and improve their productivity. Now, in the biennial, advantage to publicize this solution which undoubtedly shall draw the attention of more a visitor on its stand in Hall 3 / C-7. In the words of Diego Carrascal, "We realized that it was a perfect product to market and a product that pays for itself in a single night".
The solution given by Rodicar to know is the new self-centring clip, which solves the problems to load hexagonal and square bars in automatic. Through a patented system of balls, which are coupled in the interior of any kind of clamp, new or used, you get the burden of 100 per cent of bars, avoiding unscheduled stops of the lathe.
It is a good solution to optimize the time in the automatic loading, which can be connected to the already existing in the workshop clamps.
A small revolution that translates into productivity
So far, as points out the commercial director of the company, there was a centrante clamp which must enter the hexagonal bar. Not always easy and it causes serious production problems by machine stoppages. Therefore, that this totally new product with world patent since two years eliminates these problems. "Five of every ten bars are not included and are taken for valid." "Now, thanks to the new clip, 100 per cent of the bars come".
Prevents machine stoppages and movements of the operator who leaves his work to address the problem. "The stipulated time to prepare the toolbar can be 10 minutes, which is daily savings of two or three hours of work."
It pays for itself in one night
"It is an ideal solution for those companies with night shifts, where perhaps the third bar may fail." With the clip we guarantee that this will not happen. "If the clip costs 300 euros, in six hours of work at night is it pays."
