The correct zero point decides production or stop

To what production with machining by chip startup is family this situation? Breakdown of the machine, stop, failure in the production, damage due to erroneous correction of the tool data. There is worldwide a machine of machining with CNC control that has not happened this, or well, at least, be daily exposed to the risk. Only in exceptional cases user time avoids this situation, or the damage only reduced to a tool or a damaged machined piece. Often, the damage is much greater: devices, the platform of palletizing or the spindle of the machine are destroyed or, at least, damaged. As a result, and not infrequently, the machine is burned in the machining of steel, copper or brass, putting out all of the machine with CNC control. This stem damage, costs and problems of supply for many companies, which is irreparable in the current economic situation.

For this reason, to Zoller, manufacturer of devices pre-reglaje and measurement of Freiberg am Neckar, was undoubtedly important to limit this risk in relation to the measurement and the pre-reglaje of machining tools. For this reason, all variants of the pre-reglaje and Zoller measuring apparatus in general offer a software for the automatic indication of the zero point. This prevents a tool is measured or conforms with the incorrect zero point in the pre-reglaje and measurement apparatus. Avoid editing and the transfer of erroneous correction measures, whose errors can reach several centimeters. Precisely in the case of a park of different machines, different kinds of tool and derivatives of this zero-point displacement, for the user or users is extremely important to work with the zero point of the correct adapter into the pre-reglaje and measuring apparatus.

Normally, it takes into account piece of corresponding voltage use, since that, otherwise, you can not capture the tool in the pre-reglaje and measurement apparatus. On the other hand, if another user has previously used another zero-point of the adapter, in practice this is not detected without an automatic indication of the zero point. If it is confirmed simply measurement, the label or the registration of data issued drag values of correction, in the worst case, several inches lower than the actual dimensions of the tool. If after machining machine uses these erroneous measurement values in the operation of the program with CNC control, this leads almost inevitably to the progress of the tool in place accelerated towards the machined piece or the device. The result is well known to all.

This kind of incidents and damage worth 100,000 euros can be avoided in a unique and easy way with devices pre-reglaje and measurement of Zoller, even in the series of devices "smile", whose total cost per unit is only 9,999 euros. Before each process of adjustment and measurement, in electronic devices the user Zoller "saturn" automatically gets an overview of the points the adapter zero stored in the system. This visual indication draws the attention of the user on the necessary selection of zero-point of the adapter with a comfortable selection from a menu of displacement. The aircraft of prereglaje and measurement with CNC control of Zoller, as for example, "venturion" with "saturn 2" and 3-axis CNC control, offer also an automatic zero-point calibration implying no effort or influence by the user. The edges of calibration by which is known to Zoller moving automatically, focus, are measured and the point zero is again measured. Below and without interruptions, continues the process of pre-reglaje and measurement selected previously with a zero point calibration again.

Point calibration interval zero can be configured according to it is refining in relation to the user, elimiando well as the effects of different environmental conditions.