ZOLLER • Pavilion 3 - Stand D24

Especially thinking of the rectification and grinding companies, the technique of verification and measurement specialist displays a wide selection of measuring instruments. They are a good example of this "genius 3" universal measuring machines and "genius 3" with cargo, both with measuring tank complete fully automatic and interface Numroto plus. And also Zoller "smarTcheck" to measure according to the needs of the workshop of the external contours of tools.

With the apparatus of pre-reglaje, contraction and universal measurement Zoller "redomatic", the nominal length adjustment is possible with a tolerance of ± 15 µ. EMO will also present the adjustment of the technology of inductive contraction to the new stécnica of the greasing of minimum quantities (MMS).

Along with the well-known series of vertical and horizontal prereglaje and measurement equipment, Zoller will additionally present special hardware and software to measure, adjust and verify reamers, holder heads and milling machines for crankshafts.

For pre-reglaje and measurement devices highly developed, the technique of verification and measurement specialist will present, in the area of technology of image processing, different completely new developments. For example, the automatic review of phyla of court, with which the work of the control of wear is reduced to a minimum. During the measurement process, creating images of incident light from the edges of cut and stored depending on the tool. Once the process of measuring, you can verify quickly and easily the status of all the edges of cut on a broad overview. A special feature is the quality of the images of the cutting edges created by the incident light LED.

In combination with Zoller "genius 3", now exists in the "preparation of the cutting edge". This process without contact, evaluates full rounding of the cutting edge of cutting bits and milling machines. Along with the visual representation with the 200 per cent increase, or optionally the 500 per cent, as a sharp image, the calculation is performed by segments of existing outline and the width.

"Assistant" software allows that all the operators, without the need of training, can create fully automatic measuring processes. In this sense, the surface is governed by the mode of work and functioning of modern controls and systems of programming for rectification and grinding machines.

Another point to increasing productivity and reducing the costs of tools is the management of resources "toolmanager". With it, can manage comfortably individual components, complete tools and resources, thus increasing the productivity of machines