Schlüter Systems, S.L. - Pavimentos sobreelevados
Schlüter Bekotec
Construction of pavimentos: with soleras floating free of cracks
The support of coatings for floors Schlüter-Bekotec is a system to place coatings durable and without cracks on solado floating or of radial heating with the minimum thickness of layers. This system bases in the signpost of poliestireno with pivotes Schlüter-Bekotec-IN that it extends directly on the base portante or on plates of thermal sensors and acoustic insulation available in the market. Of the configuration of the signpost with pivotes Schlüter-Bekotec-IN deduces a minimum thickness of the layer of solado of 32 mm between the pivotes and of 8 mm above these, serving of reference the four high points of each plate to level the minimum layer of the solado.
The pivotes form a mesh of 75 mm in which they can place tubes of 10 to 18 mm of diameter to install a radial heating.
Since the mass of layer that has to heat or cool is very reduced, the heating of the radiant floor can regulate well and allows to keep his operation to low temperature.
Since the mass of layer that has to heat or cool is very reduced, the heating of the radiant floor can regulate well and allows to keep his operation to low temperature. Therefore, it is not necessary to place boards of partition in the layer. When already it can walk on the solado Bekotec hits the esterilla of decoupling Schlüter-Ditra. On this can place directly baldosas of ceramics or of natural stone on a fine layer of cement tail.
The boards of movement in the layer of revestimiento have to establish in the distances required usually by means of Schlüter-Dilex. The materials of revestimiento resistant to the cracks as, for example, the parquet or the moquetas can place directly on the layer after deleting the corresponding remaining humidity.
Schlüter-Bekotec-IN 2620P is of poliestireno PS 25 and especially appropriate for the utilisation of solado of conventional cement of the class of minimum resistance ZE 20.
Schlüter-Bekotec-IN 1520PF is of poliestireno PS 15 and his upper face is covered of a film. It is especially appropriate for fluent mortar. The material PS 15 allows to improve the acoustic isolation.
The pivotes form a mesh of 75 mm in which they can place tubes of 10 to 18 mm of diameter to install a radial heating.
Since the mass of layer that has to heat or cool is very reduced, the heating of the radiant floor can regulate well and allows to keep his operation to low temperature.
Since the mass of layer that has to heat or cool is very reduced, the heating of the radiant floor can regulate well and allows to keep his operation to low temperature. Therefore, it is not necessary to place boards of partition in the layer. When already it can walk on the solado Bekotec hits the esterilla of decoupling Schlüter-Ditra. On this can place directly baldosas of ceramics or of natural stone on a fine layer of cement tail.
The boards of movement in the layer of revestimiento have to establish in the distances required usually by means of Schlüter-Dilex. The materials of revestimiento resistant to the cracks as, for example, the parquet or the moquetas can place directly on the layer after deleting the corresponding remaining humidity.
Schlüter-Bekotec-IN 2620P is of poliestireno PS 25 and especially appropriate for the utilisation of solado of conventional cement of the class of minimum resistance ZE 20.
Schlüter-Bekotec-IN 1520PF is of poliestireno PS 15 and his upper face is covered of a film. It is especially appropriate for fluent mortar. The material PS 15 allows to improve the acoustic isolation.
